In this section
Many Tribology Group publications are Open Access thanks to funding from the EPSRC.
@article{Kanazawa:2017:10.1016/j.triboint.2017.01.026,
author = {Kanazawa, Y and Sayles, RS and Kadiric, A},
doi = {10.1016/j.triboint.2017.01.026},
journal = {Tribology International},
pages = {505--518},
title = {Film formation and friction in grease lubricated rolling-sliding non-conformal contacts},
url = {http://dx.doi.org/10.1016/j.triboint.2017.01.026},
volume = {109},
year = {2017}
}
TY - JOUR
AB - This study investigates the film formation and friction in grease lubricated, rolling-sliding, non-conformal contacts over a range of entrainment speeds, surface roughnesses and contact temperatures. The effects of grease composition are assessed by employing custom made, additive free, lithium and diurea thickened greases, whose composition is systematically varied so that the effects of the thickener and the base oil can be isolated. All film thickness and friction measurements were conducted under fully-flooded conditions. It was found that at low speeds all tested greases are able to form thicker films than the corresponding base oils. The thickness and behaviour of these films is determined by the thickener type and is independent of the base oil viscosity and the test temperature. At higher speeds, the film thickness is governed by the base oil properties alone and can be predicted by the EHD theory. At low speeds, films with diurea greases grow with time under constant speed and residual films persist under load after contact motion ceases. The real lambda ratio, based on measured grease film thickness, was shown to correlate well with contact friction. The transition from the thickener dominated behaviour to that dominated by the base oil occurs at a relatively constant film thickness, regardless of the base oil viscosity and test temperatures, rather than at a given entrainment speed. Based on the presented evidence, it is here proposed that the mechanism of formation of grease films at low speeds, is analogous to that reported to operate in EHL contacts lubricated with colloidal dispersions, namely the mechanical entrapment and deposition of thickener fibres, and that, rather than the widely quoted ‘transition speed’, it is the ratio of the thickener fibre size to prevailing film thickness that determines the range of conditions under which the film enhancement due to the action of thickener is present.
AU - Kanazawa,Y
AU - Sayles,RS
AU - Kadiric,A
DO - 10.1016/j.triboint.2017.01.026
EP - 518
PY - 2017///
SN - 1879-2464
SP - 505
TI - Film formation and friction in grease lubricated rolling-sliding non-conformal contacts
T2 - Tribology International
UR - http://dx.doi.org/10.1016/j.triboint.2017.01.026
UR - http://hdl.handle.net/10044/1/44604
VL - 109
ER -